Thanks Anne, I think the definition should be read in full to appreciate the intent as this refers to ‘valid reasons’ and one particular circumstances’ amongst other important elements: This word, or the adjective "RECOMMENDED", mean that there may exist valid reasons in particular circumstances to ignore a particular item, but the full implications must be understood and carefully weighed before choosing a different course. Kind regards, Martin Sent from my iPhone On 26 May 2020, at 17:37, Jeff Neuman <jeff.neuman@comlaude.com> wrote: <image004.gif> Thanks Anne. I don’t believe we have ever said that the IETF definitions are the ones we adopting. They are helpful, but they are not the ones we have adopted. We will make this clear. Jeff Neuman Senior Vice President Com Laude | Valideus D: +1.703.635.7514 E: jeff.neuman@comlaude.com<mailto:jeff.neuman@comlaude.com> From: Gnso-newgtld-wg <gnso-newgtld-wg-bounces@icann.org> On Behalf Of Aikman-Scalese, Anne Sent: Tuesday, May 26, 2020 12:34 PM To: gnso-newgtld-wg@icann.org Subject: [Gnso-newgtld-wg] MUST, SHOULD, SHALL etc Jeff, Cheryl, et al – below I paste the IETF definitions that were linked – note, for example, that “should” says “can be ignored” under certain circumstances – not sure anyone in the WG ever had that understanding of “should”. Anne Network Working Group S. Bradner Request for Comments: 2119 Harvard University BCP: 14 March 1997 Category: Best Current Practice Key words for use in RFCs to Indicate Requirement Levels Status of this Memo This document specifies an Internet Best Current Practices for the Internet Community, and requests discussion and suggestions for improvements. Distribution of this memo is unlimited. Abstract In many standards track documents several words are used to signify the requirements in the specification. These words are often capitalized. This document defines these words as they should be interpreted in IETF documents. Authors who follow these guidelines should incorporate this phrase near the beginning of their document: The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119<https://tools.ietf.org/html/rfc2119>. Note that the force of these words is modified by the requirement level of the document in which they are used. 1<https://tools.ietf.org/html/rfc2119#section-1>. MUST This word, or the terms "REQUIRED" or "SHALL", mean that the definition is an absolute requirement of the specification. 2<https://tools.ietf.org/html/rfc2119#section-2>. MUST NOT This phrase, or the phrase "SHALL NOT", mean that the definition is an absolute prohibition of the specification. 3<https://tools.ietf.org/html/rfc2119#section-3>. SHOULD This word, or the adjective "RECOMMENDED", mean that there may exist valid reasons in particular circumstances to ignore a particular item, but the full implications must be understood and carefully weighed before choosing a different course. 4<https://tools.ietf.org/html/rfc2119#section-4>. SHOULD NOT This phrase, or the phrase "NOT RECOMMENDED" mean that there may exist valid reasons in particular circumstances when the particular behavior is acceptable or even useful, but the full implications should be understood and the case carefully weighed before implementing any behavior described with this label. Bradner Best Current Practice [Page 1] ________________________________ RFC 2119<https://tools.ietf.org/html/rfc2119> RFC Key Words March 1997 5<https://tools.ietf.org/html/rfc2119#section-5>. MAY This word, or the adjective "OPTIONAL", mean that an item is truly optional. One vendor may choose to include the item because a particular marketplace requires it or because the vendor feels that it enhances the product while another vendor may omit the same item. An implementation which does not include a particular option MUST be prepared to interoperate with another implementation which does include the option, though perhaps with reduced functionality. In the same vein an implementation which does include a particular option MUST be prepared to interoperate with another implementation which does not include the option (except, of course, for the feature the option provides.) 6<https://tools.ietf.org/html/rfc2119#section-6>. Guidance in the use of these Imperatives Imperatives of the type defined in this memo must be used with care and sparingly. In particular, they MUST only be used where it is actually required for interoperation or to limit behavior which has potential for causing harm (e.g., limiting retransmisssions) For example, they must not be used to try to impose a particular method on implementors where the method is not required for interoperability. 7<https://tools.ietf.org/html/rfc2119#section-7>. Security Considerations These terms are frequently used to specify behavior with security implications. The effects on security of not implementing a MUST or SHOULD, or doing something the specification says MUST NOT or SHOULD NOT be done may be very subtle. Document authors should take the time to elaborate the security implications of not following recommendations or requirements as most implementors will not have had the benefit of the experience and discussion that produced the specification. 8<https://tools.ietf.org/html/rfc2119#section-8>. Acknowledgments The definitions of these terms are an amalgam of definitions taken from a number of RFCs. In addition, suggestions have been incorporated from a number of people including Robert Ullmann, Thomas Narten, Neal McBurnett, and Robert Elz. Anne E. Aikman-Scalese Of Counsel 520.629.4428 office 520.879.4725 fax AAikman@lrrc.com<mailto:AAikman@lrrc.com> _____________________________ <image005.png> Lewis Roca Rothgerber Christie LLP One South Church Avenue, Suite 2000 Tucson, Arizona 85701-1611 lrrc.com<http://lrrc.com/> <image006.jpg> Because what matters to you, matters to us.™ ________________________________ This message and any attachments are intended only for the use of the individual or entity to which they are addressed. If the reader of this message or an attachment is not the intended recipient or the employee or agent responsible for delivering the message or attachment to the intended recipient you are hereby notified that any dissemination, distribution or copying of this message or any attachment is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the sender. The information transmitted in this message and any attachments may be privileged, is intended only for the personal and confidential use of the intended recipients, and is covered by the Electronic Communications Privacy Act, 18 U.S.C. §2510-2521. ________________________________ The contents of this email and any attachments are confidential to the intended recipient. They may not be disclosed, used by or copied in any way by anyone other than the intended recipient. If you have received this message in error, please return it to the sender (deleting the body of the email and attachments in your reply) and immediately and permanently delete it. Please note that the Com Laude Group does not accept any responsibility for viruses and it is your responsibility to scan or otherwise check this email and any attachments. The Com Laude Group does not accept liability for statements which are clearly the sender's own and not made on behalf of the group or one of its member entities. The Com Laude Group includes Nom-IQ Limited t/a Com Laude, a company registered in England and Wales with company number 5047655 and registered office at 28-30 Little Russell Street, London, WC1A 2HN England; Valideus Limited, a company registered in England and Wales with company number 06181291 and registered office at 28-30 Little Russell Street, London, WC1A 2HN England; Demys Limited, a company registered in Scotland with company number SC197176, having its registered office at 33 Melville Street, Edinburgh, Lothian, EH3 7JF Scotland; Consonum, Inc. dba Com Laude USA and Valideus USA, headquartered at 1751 Pinnacle Drive, Suite 600, McLean, VA 22102, USA; Com Laude (Japan) Corporation, a company registered in Japan having its registered office at Suite 319,1-3-21 Shinkawa, Chuo-ku, Tokyo, 104-0033, Japan. For further information see www.comlaude.com<https://comlaude.com> _______________________________________________ Gnso-newgtld-wg mailing list Gnso-newgtld-wg@icann.org https://mm.icann.org/mailman/listinfo/gnso-newgtld-wg _______________________________________________ By submitting your personal data, you consent to the processing of your personal data for purposes of subscribing to this mailing list accordance with the ICANN Privacy Policy (https://www.icann.org/privacy/policy) and the website Terms of Service (https://www.icann.org/privacy/tos). You can visit the Mailman link above to change your membership status or configuration, including unsubscribing, setting digest-style delivery or disabling delivery altogether (e.g., for a vacation), and so on.
